Error in job Job-2: THE PROBLEM IS TOO LARGE TO RUN WITH Abaqus.
Large warping that develops during an analysis often corresponds to severe distortion of the underlying elements.
Please report any * * errors encountered in either the documentation or results * * immediately to LST through your site focus.
如標題，沒有錯誤和警告的信息實在不知道該從哪里開始檢查。后來發現電腦容量剛好不夠了，這是否可能是因為電腦容量不足導致的？
the problem is too large to run with abaqus. typically this caused by the existence of a very large element such as a substructure with a large number of retained dof. a large cavity in a cavity radiation
Solver problem. Numerical singularity when processing node TERMINAL-1.136 D.O.F. 1 ratio = 100.E+09 .Material/behavior grip has been redefined in the current analysis.
請問大家在進行abaqus仿真時，有沒有可能因為電腦睡眠或者斷網而造成這種錯誤？
小弟做一個顆粒壓縮場景，材料就用彈塑性模型，顆粒模型核模具如圖，其中模具部分設置為了剛體，120s的顯式分析，加載為100MPa，現在有兩個問題，首先是計算過慢，如監控器中所示，整體網格也就五萬多，CPU是9950x，14核計算，剛開始兩分鐘出0.06s，后面掉到0.004s了，模型也不大，質量縮放給的5，該怎么優化呢？此外就是算到2s多就出現標題的提示報錯，上網查了說了網絡問題，但網絡一直連著，
This may cause convergence problems.
. ************************************************************************ OptiStruct error termination report printed to file "h22.stat".
螺栓連接鋼管混凝土，三個分析部，一二是螺栓荷載施加，能夠計算，第三步在柱頂與截面耦合的點施加一個豎向位移，計算了幾步就不收斂了，顯示“ The analysis has been terminated due to previous errors.
*** ERROR 14: Missing property # 2 referenced by CQUAD4 # 13393. **************** Too many error messages. Aborting run. Current limit is 10000.
If there are no error messages and you cannot resolve the problem,please run the command "abaqus job=support information=support" to report andsave your system information.
If there are no error messages and you cannot resolve the problem, please run the command "abaqus job=support information=support" to report and save your system information.
跳至頁
工程師必備
- 項目客服
- 培訓客服
- 平臺客服
TOP
