不知火舞的被虐|伊人天伊人天天综合网|博洛尼亚天气|任你懆这里只有精品4|久久美日韩精品久久|掌中之物漫画免费阅读观看|0丨d老妇

IF ONE PAIR IS *TIE AND ANOTHER IS *CONTACT PAIR, REMOVE ONE OF THEM. abaqus出現以上問題該如何解決？

材料屬性里我也沒有用umat，檢查了好多次也不知道出了啥問題，一直報這個錯誤T T

*** ERROR # 163 *** Too many vibration modes exist in the range of interest. Solver error no. = 725 subcase id = 1 This error happens as there are more than 500 eigenvalues

Error 30280 (INI+280) Negative volume check the seg normal *** Error 20018 (STR+18) input phase completed with 1 fatal errors please check messag file

In Model: Model-1, the rigid part instance: impactor is missing a reference point.Either assign a reference point to the corresponding part,

每次打開文件都會提示，材料庫是空的，材料，風扇之類的都沒有，怎么解決？

abaqus創建作業時出現：rom_MementoRead::rom_MementoRead-對象在DB文件ajbC_ModelJob[11]中不可用，不能創建作業，

Beginning of keyword reader 03/10/25 15:53:06 Memory required to process keyword : 31636524 *** Warning 21131 (STR+1131)

illegal applicable dof on vel. Card= 1 Code = 0.

For two-dimensional models, if a non-unity thickness is specified for two-dimensional solidelements and these elements are involved in an interaction such as contact, the same thicknessshould be specified

The mesh file exporter does not support overlapping geometry in named selections. Please resolve the issue and try again. You can use the option “Show Geometry in Overlapping Named Selections” (when

in keyword *RIGIDBODY, file "hg1.inp", line 17729: Unknown assembly set

使用linux超算服務器跑仿真時，出現了以下錯誤，但在網上都沒有搜到可用的解決辦法。Abaqus Warning: The following input options are not supported by parallel execution of element operations: adaptivemesh.