THE SLAVE SURFACES ASSEMBLY_GROUTING-1_G1-I AND ASSEMBLY_GROUTING-1_G2-I INTERSECT EACH OTHER.
如果一對是領帶，另一對是接觸線，請取下其中一對。THE SLAVE SURFACES ASSEMBLY_CP-1-PART-TCXC-S-1 AND ASSEMBLY_CP-2-PART-TCXC-S-1 INTERSECT EACH OTHER.
No surface facets are generated for surface assembly__pickedsurf1527.這是什么意思？
THE SLAVE SURFACES ASSEMBLY CP-1-CONCRETE-1 AND ASSEMBLY_CP-4-CONCRETE-1 INTERSECT EACH OTHER.
***ERROR: THE SLAVE-MASTER PAIR ASSEMBLY_DBDSL-ASSEMBLY_DBDMS SPECIFIED ON *DEBOND HAS NOT BEEN DEFINED.
THE SLAVE SURFACES ASSEMBLY__PICKEDSURF70 AND ASSEMBLY__PICKEDSURF88 INTERSECT EACH OTHER. THEY ARE PAIRED WITH MASTER SURFACES ASSEMBLY__PI
Surface assembly__pickedsurf15 has facets that are not oriented properly with respect to each other.
以下是status文件相關信息***WARNING: Master surface ASSEMBLY_SURF-CU-3 of contact pair # 5 contains facets with out-of-plane warping of at least 20.000 degrees in increment 22480.
The *tie pair (assembly_surf-26-ouhemian,assembly_surf-19) is also used as *contact pair. Remove this *contact pair.
但是導到abaqus里算題的時候報錯了The slave surface assembly_zhouwa1-2 has 1245 nodes in common with its master surface assembly_muju-2.翻譯過來就是兩個面有公共節點。請問有什么辦法？
The contact pair referencing surfaces assembly_m_surf-1 and assembly_s_surf-1 has at least one instance of a node belonging to both surfaces.
ABAQUS數據檢查時出現錯誤：主從截面共節點問題The slave surface assembly_s_surf-69 has 1780 nodes in common with its master surface assembly_m_surf-63.是什么原因呀？
報錯內容：Surface assembly has facets that are not oriented properly with respect to each other.
在學習了您的水下爆炸對結構損傷的分析課程后，我對照著您請的內容，做了一遍，在將inp文件放入job中檢查時，提示出錯，未見設置的兩個接觸面，如下：Surface definition assembly_surf-waterjiechu not found.Surface definition assembly_surf-boxjiechu not found.
邊界條件設置為：1）歐拉體頂端外沿V1=0(不發生外流) 2）歐拉體截面設置V2,VR1,VR3=0(對稱面) 3）歐拉體外側一圓弧包圍范圍內設置了free inflow oulflow的設置，同時在load上對該位置施加pressure載荷 4）接觸設置為general contact，但是不包括四個surface-surface接觸，不包括的四個surface采用了surface
PENETRATION ERROR 325.303E-06 AT NODE CRCP-1.95375 OF CONTACT PAIR (ASSEMBLY_CRCP-UPPER,ASSEMBLY_AC-20-LOW) MAX.
Similarly, adjustments for double-sided surfaces crossing each other may be incorrect and no additional warnings or error messages will be issued.
跳至頁
工程師必備
- 項目客服
- 培訓客服
- 平臺客服
TOP
