1.
初次按照ICEM CFD例題4.3.1中生成網格時，沒有生成block，
只是先劃分面網格，后來extrude mesh，接著生成了一系列的Subsets，
導入CFX5.7時出錯：
ERROR
There was a problem importing the mesh from the requested file.
The importing process reported the following problem:

Unable to import mesh: Insufficient memory to 3D region.
后來用CFX 10.0 導入就沒有問題了，但CFX 5.7讀入CFX 10.0的定義文件*.cfx
時也出錯了：
ERROR
CCL validation failed with message:
Can't call method "allowAnyObject" on an undefined value
at C:\CFX\CFX-5.7\lib\ccl/CCL/Validate/Object.pm line 295.

WARNING
There was an inconsistency between the state of Pre
and the gtm database.

The following objects have been added:
/ASSEMBLY:Assembly

因此 CFX 10.0計算時應該注意。

同時CFX 10.0導入后沒有相應的面(2D_region可以用來生成邊界條件)
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

2.
上面問題已經解決
在 ICEM CFD 中 Parts 中 分別建立相應的邊界條件的面。
但如果面劃分網格時切成幾個部分時(上、中、下部三個矩形，便于劃分標準網 格)，導入CFX 10.0 時mesh中有幾個Assembly。在計算時進行不下去，提示
3 isolated fluid regions were found in domain Buoyant

If the isolated regions do not have the pressure level set either
by the boundary conditions or using a reference pressure equation,
you may encounter severe robustness problems.

This situation may have arisen because a domain interface was not
properly defined during problem setup. Please carefully check
the setup.

The solver will stop now and write a results file. The isolated
regions can be visualised in CFX Post by making plots of the
variable "Isolated Volumes".

If you are sure that the pressure level is set in each isolated
fluid region then you can force the solver to turn off this check
by setting the expert parameter "check isolated regions = f".

3.
建模時 body 不會輸入到網格中 只有劃分的網格可以輸入

4.
問題2中的已經解決，在建模時，把不同region間的網格刪除就可以了，呵呵。